Hi Paul,
With a large number of steps in a project, it would make life easier for a user to be able to do a select all steps to skip and then un-check the few that are required
Regards
Bruce
Hi Paul,
With a large number of steps in a project, it would make life easier for a user to be able to do a select all steps to skip and then un-check the few that are required
Regards
Bruce
Thanks for the suggestion Bruce, it’s done and will be in the next release.
Paul
Hi Paul,
I think this is related to the performance of NuGet feeds, see the other email I’ve just sent through
Regards
Brcue
Bruce Keen
15below ltd : 15below Australia pty ltd
E: bruce.keen@15below.com
• @15below_travel
Bruce Keen would like to recall the message, “Enable user to select all when selecting steps to skip on the Create Deployment screen [Ideas and suggestions]”.
15below Limited: Company registered in England and Wales No 3945289
Registered Office: Lyndean House, 43-46 Queens Road, Brighton BN1 3XB, United Kingdom
15below Australia Pty Limited: ABN 25 132 716 379
Level 50, 120 Collins Street, Melbourne, Victoria 3000, Australia
Please think about the environment before printing this email.
This email and any attachments may be confidential and/or legally privileged and are solely for the use of the intended recipient. If you have received this email in error please contact the sender. Any views or opinions expressed within this e-mail are solely those of the sender, and do not necessarily represent those of 15below unless otherwise specifically stated. Although 15below has taken every reasonable precaution to ensure that any attachment to this e-mail has been checked for viruses, it is strongly recommended that you carry out your own virus check before opening any attachment, as we cannot accept liability for any damage sustained as a result of software virus infection.
Hi Bruce,
This fix was included in today’s release
Paul